Throttle Cable Stuck On Dirt Bike

A stretched throttle cable won t give your bike much life and obviously a broken cable doesn t work but a sticky cable or throttle tube can produce these kinds of results.

Throttle cable stuck on dirt bike.

How to fix replace throttle cable on a dirt bike it s not that hard just keep focused on how you took it a part to get it back together. This is on my 1993. Pretty darn cool bike actually. Additionally the throttle cable just through general wear and tear stretches breaks or thanks to the dirt build up gets sticky too.

Not only was the dirt bike throttle sticking it was not snapping back and it seemed like the throttle wouldn t return. The throttle cable is a critical component to your bike s function but it s often overlooked. If you ve ever had a dirt bike that the throttle sticks or that the throttle return action is a little slow and stays on long after you re done using it or if you ve ever had to or still do now turn the throttle back to closed manually when you are ready to shut off you re braver than i if you re still riding it and the tips below will ensure your throttle reliably snaps shut and should. It had a definite and annoying stick at the start.

So you want to know how to clean the throttle cable on a dirt bike. But within 2 7 seconds ish of riding it i could tell that the throttle needed some attention. Motorcycle throttle cables consist of two steel cables that run from the grip of the throttle to the engine to open and close the carburetor. Drivers use these two cables the front cable and the idle hand throttle cable to accelerate the bike just like a pedal is used to accelerate a car.

Little else terrifies a rider on a dirt bike when that pin gets stuck. Follow the guidelines below to make sure you re not stuck with a malfunctioning throttle. Inspect the throttle cable that it s routed properly and doesn t get pinched by the handlebars turning motion and not intertwined with the brake or clutch cables and electric start cable if applicable.